USER MANUAL | ICOS | INSTRUCTIONS | UM/ICOS-EN REV. B.2
Replace the Fuse
If the fuse blows or is otherwise damaged, the analyzer automatically turns off.
To replace the fuse:
1.
Flip the Power switch to OFF on the left side of the analyzer. (Figure 4)
2. Unplug the 11-30 VDC power connector from the left side of the analyzer. (Figure 4)
3. Unlatch the Case Securing Latches. (Figure 42)
a. Push the latch button.
b. Pull down on the latch.
4. Open the case top. (Figure 43)
Figure 42: Case Securing Latches
Figure 43: Open the Case Top
60