AEG IKK86681FB User Manual page 15

accordingly. You can place the cookware
on the left, centre, or right vertical bridge.
General information:
• For this function, use cookware with
the minimum bottom diameter of 160
mm.
• The zone indicator indicates both
zones in a bridge even if only one of
the zones is used.
• You may adjust the heat setting
manually only if at least one of the
zones is activated automatically.
• You can change the heat settings for
each position separately. When you
deactivate the hob, it remembers your
heat settings and applies it next time
you activate the function.
• If you want to change the heat setting,
lift up the cookware and place it on a
different zone. Sliding the cookware
can cause scratches and
discolouration of the surface.
Activating the function
To activate the function, press
the function is activated, the symbol
turns red and the control bar displays the
pre-set power level.
If there is no cookware
detected on the cooking
zones, after 9 minutes an
acoustic signal sounds and
the cooking zones
deactivate automatically.
Press to resume this
function.
Adjusting power level
To adjust the power level, choose the
heat setting on the control bar.
Deactivating the function
To deactivate the function, press
6.5 OffSound Control
(Deactivating and activating
the sounds)
Deactivate the hob. Press
seconds. The display comes on and
goes out. Press for 3 seconds.
appears. Press
choose one of the following:
•
•
To confirm your selection wait until the
hob deactivates automatically.
When the function is set to
hear the sounds only when:
• you touch
• Minute Minder comes down
• Count Down Timer comes down
• you put something on the control
panel.
6.6 Power management
If multiple zones are active and the
consumed power exceeds the limitation
of the power supply, this function divides
the available power between all cooking
zones. The hob controls heat settings to
protect the fuses of the house
installation.
. When
• Cooking zones are grouped according
to the location and number of the
phases in the hob. Each phase has a
maximum electricity loading of 3680
W. If the hob reaches the limit of
maximum available power within one
phase, the power of the cooking
zones will be automatically reduced.
• For cooking zones that have a
reduced power, the control panel
shows the maximum possible heat
settings. The heat setting may be 0
when the other pots consume the
maximum available power. As a
result, you cannot activate any other
zone.
• If a higher heat setting is not available
reduce it for the other cooking zones
first.
.
• The activation of the function depends
on the number and size of pots.
Refer to the illustration for possible
combinations in which power can be
distributed among the cooking zones.
for 3
or
of the timer to
- the sounds are off
- the sounds are on
ENGLISH 15
you can