NorthStar NS3300 AutoPilot Installation Manual page 13

Installing a electric drive motor with clutch relay
In the Setup > Vessel menu (See PILOT 3300 system Reference manual), set Drive Type to Motor.
Installing a continuous running pump and solenoid valves.
In the Setup > Vessel menu (See PILOT 3300 system Reference manual), set Drive Type to Spool ground.
Reference Manual
Fit strain relief
Heavy duty power (see section 3-4-1)
1N4002 diode or equivalent
Relay contacts
Fit close to relay coil
Clutch
coil
Wiring polarity
does not matter.
Motor
Fit strain relief
Heavy duty power (see section 3-4-1)
Motor
Note: Motor is not
required for engine
PTO systems.
does not matter.
Starboard
Port
MCU600
Connector
cover
Relay coil
1N4002 diode or equivalent.
Fit close to relay coil
Note: Relay is required if the clutch
circuit is greater than 300 mA.
MCU600
Connector
cover
Relay contacts
Wiring polarity
Relay coil
1N4002 diode or equivalent
Fit close to relay coil
Note: Relay is required if the clutch
circuit is greater than 300 mA.
15