Connecting the 490 to the
490 INSTALLATION MANUAL, Revision B2
Table 3: Cable connection between the 961/962 and 490 (cont.)
961/962 pin number
13
16
**
* Connector P1, pin 12 on the 961/962 requires two connections from the cable.
**The red wire is not connected on the 961/962 end, and should be insulated and capped.
The connection between the 957/958 and the 490 requires the
957/958
10-foot (3-meter) data cable supplied by Northstar. The cable
connects to the AUX port on the back of the 957/958.
Figure 9 below illustrates the wiring for the 957/958 end of the
cable. Table 4 describes the pin's functions.
Figure 9: Interface cable connection from 957/958 to 490
Table 4: Cable connection between the 957/958 and 490
957/958 pin number
1*
1*
2
3
SECTION THREE Installing the 490
961/962 P1 signal name
Port 3 Out (B)
Ground
Not connected
Brown (1)
Green (1)
White (2)
Blue (6)
Orange (5)
Violet (4)
Black (3)
AUX port signal name
Shield/Gnd
Remote On Gnd
Remote On input
NMEA AUX In (B)
Cable wire color
Orange
Green
Red
Cable wire color
Brown
Green
White
Black
Page 19