Training wheels are inapplicable to this bike
1. Preparation:
1.Flip the kickstand down to keep the bike upright
2.Scissors(not included in the package)
3.check to see if all accessories are included
Remove recyclable protecting films and pads(P1, P2).
P
P
1
2
Front Reflector----Fixed on the handlebar
Rear Reflector----Fixed on the bracket of the right rear fork
2. Handlebar installation
1. Remove the protection
Remove the protection cover
on the ①stem wedge.
Troubleshooting
a. If the cover is too tight
and unable to remove,
use a wrench and turn
the cover counter-
clock-wise until loosen.
stem wedge
b. Make sure the stem
wedge is connected to the
stem and not stucked in
the cover.
三、 安装鞍座
Minimum insertion line must
be hidden within the seat tube
of the bike.
Now you have acquired the
essential assembly skill of the EZ
bike. Try to slide, gain some
balance skills, and move on to
putting on the pedals for biking.
EZ FREESTYLE ASSEMBLY GUIDE
Please consult our after service representative regarding any problem during assembly or using.
RoyalBaby After Service Toll Free Number: +1 888-881-BIKE(2453)
Email: service@royal-bike.com
⑧
Crank Pedal
⑨
Dust cap
Stem bolt
①
Minimum insertion
line must be hidden
within the headtube
of the bike.
1.Saddle installation
Loosen the ⑤quick-release lever and insert the ④
seat post into the ⑥seat tube.
Warning: The seat pillar must be inserted so that the
minimum insertion mark cannot be seen.
Crank Pedals Installation
1. Remove the⑦ center axle protection pad
b. Pull out the center axle protection pad.
a. Press the red triangular
(Do not pull until the button is pressed to
button all the way down
the bottom)
③
Brake lever
①
②
Head tube
2. Stem Installation
Install the ①stem into the ②head tube, and tighten
the stem bolt clockwise.
Warning:
a. Minimum insertion line must be hidden within the headtube
of the bike.
b. Ensure the brake cables are frontward facing and insert the
stem into the head tube
Troubleshooting:
a. Handlebar not aligned: Make sure the handlebar is
perpendicular to the front wheel.
②
b. Handlebar is loose: Tighten the stem bolt until the
handlebar is secured.
c. Handlebar cannot
a
2. Install the ⑧crank pedals
a. Locate the center axle bolt
Stem
④
Seat post
⑥
Seat tube
⑦
Center axle protection pad
2.Secure the seat
Securely tighten the (a)seat post clamp bolt.
Securely close the (b)quick-release lever.
Troubleshooting: If the seat sways, tighten the (a)
clamp bolt until the seat is secured.
b
b. Slide the pedal arm into the bottom
bracket. The pedal arm is securely
tightened after hearing a click.
Scan QR Code for
Installation Video
⑤
Quick release
3. Secure the brake lever
Tilt the ③brake lever 30-40
degrees downward and
tighten the adjustment
screw clockwise with a hex
wrench
Need help?
Do you have a question about the EZ FREESTYLE and is the answer not in the manual?
Questions and answers