Table of Contents
Advertisement
SECTION ONE: Introduction
Scope of this
manual
For instructions on using
the 957, see the Northstar
957 Operator's Manual
(part number GM957UG)
Major installation
steps
Page 2
In this manual, you'll find information about the following
topics:
•
wiring and installing the 957
•
wiring and installing the 2201 antenna or optional 2701
DGPS/WAAS receiver
•
configuring the NMEA ports for NMEA 0183 devices
•
configuring the AUX port for the optional 490 echo
sounder
•
interfacing the 957 with an optional remote display
•
NTSC video inputs for docking, engine room, security,
entertainment, etc.
•
testing and troubleshooting the 957 installation
•
the technical specifications for the 957, 2201 antenna, and
2701 receiver
For instructions on connecting the 957 to the Northstar 490
echo sounder, see the Northstar 490 Installation Manual (part
number GM491), included in the 490 shipping carton.
The following list of recommended installation steps isn't a
substitute for all the details in this manual. To ensure that you
meet all of the installation requirements, be sure to read this
entire manual and follow its recommendations closely.
Northstar suggests following the steps as outlined below.
PRE-INSTALLATION:
Step 1. Check the shipping carton for any damage, and
immediately report any damage to the carrier. Save all
packing material in case you have to return any system
components to the Northstar factory for service.
Step 2. Fill out the warranty card and mail it to Northstar.
Step 3. Unpack the carton, and check its contents. You should
have received the following parts:
•
957 unit
•
flush-mount hardware kit (P/N 957PK)
•
flush-mount gasket (P/N HG366)
•
10-foot interface cable (P/N WA215)
•
10-foot power cable (P/N WA535-A)
957 Installation Manual, Revision C1
Advertisement
Table of Contents
