NorthStar 6000i Installation Manual page 19

connected to the narrow tabs and the contacts are connected to the wide tabs
(labelled COM and NO).
If the relay is used for power control, the navigator's Honk output must be
configured for power control as follows:
1. Press the STAR key to display the alarms page.
2. Press the Cursor Pad down to highlight " Honk Output. "
3. Press Edit , press the Cursor Pad up or down to display REMOTE PWR .
4. Press ENTER .
The 200ppnm or alarm outputs can not be used when this output is used for power
control.
Connecting the radar control box to the navigator
The WA215 interface cable plugs into the navigator's 18-pin connector. It must be wired to the
unfabricated end of the cable from the radar control box using terminal strips as shown in Figure 1
on page 3. See Table 10 for the correct wiring.
Radar Installation Manual, Rev. E1
TABLE 10: Wiring the Navigator to the radar control box
RADAR DATA CABLE
(P/N MDS–2/3)
Wire color Function
Orange Data Out+
Yellow Data Out-
Black x 2 ea Ground
Brown Data In+
Red Data In-
HEADING SENSOR
NMEA Data Out –
NMEA Data Out +
Important: Blue and Green wires from the radar data
cable are for power control and must be wired
according to one of the options shown in
power control"
SECTION TWO: Installing and wiring the radar
NAVIGATOR I/O CABLE (P/N WA215)
Wire color Function
Brown/white NMEA Port 2 In B
White/brown NMEA Port 2 In A
Black NMEA Port 2 Out Ground
Orange NMEA Port 2 Out B
Yellow NMEA Port 2 Out A
NAVIGATOR I/O CABLE (P/N WA215)
Blue NMEA Port 1 In B
Brown NMEA Port 1 In A
on page 14.
Pin #
2
6
10
11
15
1
3
"Radar
Page 15