SECTION TWO: Installing and wiring the radar
Mounting bolts (4)
Cable shield
terminal
Washer
Scanner
housing
Connecting a ground wire
Connect a grounding wire from one of the bolts on the scanner base, as shown in Figure 13 below
(the crimp terminal and grounding wire are installer-supplied).
Page 12
Remove connectors
Keep the cable shield braid
as short as possible
Connecting
cable
Figure 12: Connecting the open array antenna cable
Cable jacket
must not exceed
1/4 inch
Rubber ring
Cable inlet
Radar Installation Manual, Rev. E1
Transceiver unit
mounting bolts (2)
Cable clamp