Table of Contents
Advertisement
Procedure 44
Activating the software for a stand-alone upgrade
For this procedure, it is assumed that you already logged on and loaded the
SMC software.
1
Enter /boot/software/cur to inspect the status of the software
package.
2
Enter /boot/software/activate n.n.n.n, where n.n.n.n is the
software version, to activate the new software package.
3
Enter y to confirm you want to activate the software.
4
Log in with the admin user and password.
Wait for the SMC to restart and initialize all system components. When the
SMC restarts, wait a few more minutes. Do not disturb the system until it
responds with the Login prompt and then wait two more minutes for the SMC
to be reinitialized.
5
Enter /info/clu to check that the SMC is running.
6
Log on to the SMC.
7
Enter /boot/software/cur to check the software status.
The software version that was previously marked as permanent is now marked
as old. The new software version is marked as permanent.
Procedure 45
Activating the software for a cluster upgrade
For this procedure, it is assumed that you already logged on and loaded the
SMC software.
1
Enter /info/summary.
2
Determine which SMC holds the cluster MIP.
The SMC with the asterisk (*) in the cluster MIP column holds the cluster MIP.
3
Log on to the SMC with the cluster MIP using the admin account through
the console or Telnet/SSH.
4
Enter /cfg/sys/accesslist/list to verify that an access list exists
that includes all addresses on the management interface. If this entry
does not exist, add it.
End of Procedure
Secure Multimedia Controller
Maintenance
Page 169 of 260
Implementation Guide
Advertisement
Table of Contents
Troubleshooting
