Setting Up Terminal Access To The Smc; Connecting The Power Supply - Nortel SMC 2450 Implementation Manual

Connecting the power supply

Setting up terminal access to the SMC

Connect the power supply using the power cord ordered for this location.
Procedure 4
Connecting the power supply
To connect the power supply, follow these steps:
1 Connect the power cord to the power receptacle on the unit's rear panel.
2 Plug the cord into a properly fused outlet.
3 Set the rear power switch to the "|" ON position.
4 Switch the power on by pressing the power button on the front panel. The
system power LED turns green to indicate that power is supplied.
For normal use, switch the power on. Always disconnect the power
before removing the unit from its installed location. Disconnect the
power by setting the rear panel power switch to OFF.
The SMC has a console port for system diagnostics and configuration. This
section explains how to connect a terminal to the console port to establish a
first console connection.
For instructions on viewing and configuring system settings using either a
console connection or network connection (via Telnet or SSH), see the
"Installation and configuration" on page 77.
Hardware installation
End of Procedure
IMPORTANT!
Secure Multimedia Controller
Page 71 of 260
Implementation Guide