Parts & Features - LG WDEP9423 Series Owner's Manual

en-us_main.book.book Page 43 Friday, February 10, 2023 8:53 AM
Problem
Food does not broil Oven controls improperly set.
properly
• Make sure you select the Broil mode properly.
Improper rack position being used.
• See the Broiling Guide.
Cookware not suited for broiling.
• Use broiling pan and grid.
Aluminum foil used on the broiling pan and grid has not been fitted properly and slit as
recommended.
• See the "Operating the Oven" section in the Operation chapter.
In some areas the power voltage may be low.
• Preheat the broil element for 5-7 minutes. See the Broiling Guide.
Oven temperature Oven sensor needs to be adjusted.
too hot or too cold
• See the "Temperature Adjustment" section in the Operation chapter.
Excessive smoking Excessive soil.
during a Self Clean
• Turn off the Self Clean function. Open the windows to rid the room of smoke. Wait until the
cycle
Burning or oily odor This is normal in a new oven.
emitting from the
• This will disappear in time. To speed the process, set a Self Clean cycle for a minimum of 3
vent
Moisture collects on This happens when cooking foods high in moisture.
oven window or
• This is normal.
steam comes from
oven vent A very wet cloth was used when cleaning the window.
• Do not use too much water when cleaning the window.
Warm air venting Warm air exhaust is needed to maintain and cool down oven temperatures. It turns off
into kitchen after automatically when the heat cools to a safe temperature.
oven has been
• This is normal.
turned off.
Parts & Features
Problem
Oven control beeps Electronic control has detected a fault condition.
and displays any F
• Turn off the oven function you are using to clear the display and stop beeping. Reprogram
code error.
The oven door is locked because the temperature inside the oven has not dropped
k is on in the display
below the locking temperature.
when you want to
cook
• Allow the oven to cool.
Oven light does not It is time to replace the bulb or the bulb is loose.
work.
• Replace or tighten bulb. See "Changing the Oven Light" section in this Owner's Manual.
Self Clean mode is cancelled. Wipe up the excess soil and reset the self clean.
hours. See the Self Clean section. (On some models)
oven. If fault recurs, record fault number and call for service.
- [Case 1 ]
Code: F-9
Cause: Oven not heating (upper oven)
- [Case 2 ]
Code: F-19
Cause: Oven not heating (lower oven)
TROUBLESHOOTING
Possible Cause & Solution
Possible Cause & Solution
43