Filling Taps Positioning - Smeg GW2145 Installation Requirements

REQUEST FOR START-UP

5.1.2 FILLING TAPS POSITIONING

The taps for the water filling must be positioned close to the appliance, in a position accessible to the user. With reference to
the following figure, the values recommended are:
I < 50 cm HC < 80 cm
fig. 6 – Schematic drawing. The filling connections can be provided on the right or left side of the appliance, always taking into account the maximum
distance indicated by the product "I".
Note to prevent the risk of clogging or damage: if the water pipe is new or has been inactive for a long time, before connecting
the water supply make sure that the water is clear and free of impurities.
CAUTION
If there is not a double hot/cold water supply, the two supply hoses (cold and hot) must be connected together through a
special Y (see image below).
fig. 7 – "Y" connection of the water filling with filters positioning.
Rev. 19 561 0151 08 - EN 11 - 18