THIS MANUAL MUST REMAIN WITH THE PRODUCT OWNER FOR FUTURE REFERENCE This product complies with ANSI standard Z21.58 / To obtain replacement parts or service contact: CSA 1.6 and has been tested and approved by Intertek. Lynx Grills, Inc. 62201 Hwy 82 West Greenwood, MS 38930 888-289-5969...
Page 3
WARNINGS WARNING READ THIS MANUAL CAREFULLY and completely before using your grill to reduce the risk of: Fire Burn hazard, personal injury or property damage Ruined steaks or other unpleasant cooking experiences Unapproved installation or servicing. THIS PRODUCT IS DESIGNED FOR OUTDOOR USE ONLY. Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury or death.
WARNINGS STATE OF MASSACHUSETTS Massachusetts requires all gas be installed using a plumber or gas fi tter carrying the appropriate Massachusetts license. 2. All permanently-installed natural gas or propane installations require a “T” handle type manual gas valve be installed in the gas supply line to this appliance. 3.
ELECTRICAL CONNECTIONS IMPORTANT SAFETY PRECAUTIONS LIGHTING INSTRUCTIONS FOR ALL ACCESSORIES Safety Practices and Precautions At Each New Season Purging the Gas Lines Match Lighting Low Heat Flame Adjustment CONTACTING CUSTOMER SERVICE SCHEMATIC LYNX LIMITED WARRANTY LYNX COMMON AREA LIMITED WARRANTY...
Be sure to hold on to the container for inspection. We cannot assume responsibility for damage or loss incurred FILE CLAIM FOR DAMAGES IMMEDIATELY, in transit. (See INDEX: "Obtaining Service from Lynx" for regardless of extent of damage. further details.) IMPORANT NOTES WHERE’S THE WIND?
Page 7
1/8 in (3.2 mm) diameter rod. If building an island that does not conform to the standard properties listed in the following pages, please contact Lynx Grills at 888-259-5969 to verify all safety requirements regarding installation have been met.
SPECIFICATIONS & INSTALLATION NOTE: Side burners may be rotated 90 degrees NOTE: For Natural Gas, the manufacturer recommends using 3/4” gas supply line. Cutout not required with LIJs 0.56” Locate a 110v 15 amp GFI outlet for rotisserie models 12.00” 2.25”...
The accessory is factory set to use either propane (LP) NATURAL GAS or natural gas (NAT). It is critical that the gas you use Lynx recommends that only qualifi ed professionals matches that which the accessory was set up for. You can perform the required plumbing on this product.
Always leak-test the connection after refi lling or exchanging LP cylinders. GAS CONVERSION KITS Gas conversion kits are available from Lynx Grills to allow the burner accessory to operate on either Natural Gas or LPG. These kits should be installed by a qualifi ed...
Page 11
2 regulators 1/2” MIP fitting included w/hose 1/2” OD Stainless Steel Flexible hose 1/2” FIP fitting included w/hose SUGGESTED GAS CONNECTIONS TO A LYNX GRILL PROPANE NATURAL MAXIMUM RUNS FOR ALL APPLIANCES ON SUPPLY LINE WARNING Run Length 3/4” Max BTU for all...
The grill accessory does not come with its own power source. It may be powered directly from your Lynx Grill. When a Lynx grill is not available or if the grill is not located close enough to the accessory a Lynx LASK (Lynx Accessory Switch Kit) is available as an optional purchase.
Page 13
TESTING THE INSTALLATION Before turning the gas supply on, check for proper installation using the following test: 1. Plug the transformer back into the receptacle. 2. Push in the gas control knob on your accessory and watch the igniter spark. 3.
Page 14
You should keep it handy for easy reference. Also, at Lynx, we enjoy hearing from our customers. We like to hear about your successes but also about any diffi culties you are having. Please feel free to contact us with any questions or problems, or just to share a new recipe.
IMPORTANT SAFETY PRECAUTIONS PLEASE REVIEW THESE IMPORTANT SAFETY PRECAUTIONS BEFORE YOU USE YOUR GRILL ACCESSORY. 1. NEVER LEAVE THE GRILL ACCESSORY UNATTENDED 10. Never use charcoal or any other solid fuel in the grill WHILE COOKING. accessory. 2. Ensure all tie-down wires have been removed from the 11.
Read the ‘User Manual/Installation Instructions’ carefully and completely before using your accessory to reduce the it must be the type specifi ed by Lynx. When a LP gas risk of fi re, burn hazard or other injury. pressure regulator and hose assembly is used, the 4/11 regulator must be removed to prevent over-regulation.
LIGHTING INSTRUCTIONS LOW HEAT FLAME ADJUSTMENT The burners on your Lynx accessory feature an adjustable low setting. Fluctuations in gas pressure, gas conversion and even in the quality of the gas itself may aff ect burner performance at the "LOW" or “MED” setting. It could be either too high or too low causing the fl...
SCHEMATIC Light Molex Male Green Female Pins Varistor Molex Female Male pins LEAD WITH PIN DEAD LEAD (NO PIN) Molex Male Molex Female Female Pins BURNER Male pins Light Light Molex Male Green Female Pins Varistor Molex Female Male pins LEAD WITH PIN DEAD LEAD (NO PIN) Molex...
Failure to 7) No one has the authority to add to or vary Lynx's perform required maintenance will void this warranty warranty, or to create for Lynx any other obligation or liability in connection with the sale or use of its products.
This warranty is limited to the replacement of 7) No one has the authority to add to or vary Lynx’s the defective parts, with the consumer paying labor. warranty, or to create for Lynx any other obligation or liability in connection with the sale or use of its products.
Need help?
Do you have a question about the SEDONA LSB501 and is the answer not in the manual?
Questions and answers