Page 1
MAKE THE MOST OF YOUR SEDONA SIDE BURNER ACCESSORY CARE & USE/INSTALLATION...
Page 2
WARNINGS WarnIng rEAD thiS mANuAl cArEfully and completely before using your grill to reduce the risk of: 1. fire 2. burn hazard, personal injury or property damage 3. ruined steaks or other unpleasant cooking experiences 4. unapproved installation or servicing. thiS prODuct iS DESigNED fOr OutDOOr uSE ONly.
Page 3
HOW TO LIGHT YOUR GRILL ACCESSORY 1. before each use, complete the checklist below. 2. make sure all burner control knobs are in the “Off” position. 3. push and hold the control knob for 2 - 5 seconds while listening for and visually verifying the ignition spark is present.
Page 4
This mAnuAL musT RemAin wiTh The PRoduCT owneR foR fuTuRe RefeRenCe. this product complies with ANSi standard Z21.58/cSA to obtain replacement parts or service contact: 1.6 latest edition and has been tested and approved by Lynx Professional Grills intertek. 5895 Rickenbacker Commerce, CA 90040 888-289-5969 SEDONA SiDE burNEr AccESSOry cArE &...
Also, at lynx, we enjoy hearing from our customers. We like to hear about your successes but also about any difficulties you are having. please feel free to contact us with any questions or problems, or just to share a new recipe.
Page 6
WARNINGS WarnIng 1. the outdoor cooking gas appliance and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of 0.5 psi (3.5 kpa). 2. the outdoor cooking gas appliance must be isolated from the gas supply piping system by closing its indi- vidual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psi (3.5 kpa).
IMpORTANT SAFETY pRECAUTIONS Please review these imPortant safety Precautions before you use your grill accessory. 1. NEVEr lEAVE thE grill AccESSOry uNAttENDED 10. Never use charcoal or any other solid fuel in the grill WhilE cOOKiNg. accessory. 2. Ensure all tie-down wires have been removed from the 11.
LiGhTinG insTRuCTions foR ALL ACCessoRies Safety practices and precautions At Each New Season purging the gas lines match lighting low heat flame Adjustment ConTACTinG Lynx CusTomeR CARe BefoRe you sTART if Shipment Arrives Damaged important Notes Where’s the Wind? how long is your run? Are you “On-the-level”?
USING YOUR ACCESSORY this manual covers several accessory appliances and optional accessories for those appliances. Accessories covered in this MAnuAl the lSb501 and lSb502 (Side burner 1 & 2) feature either one or two 12,500 btu/hr burners for cooking smaller food items.
1, 20 lb lp cylinder is required, a lp gas pressure regulator and hose assembly is required and it must be the type specified by lynx. (See iNDEX: “con- tacting lynx”.) When a lp gas pressure regulator and hose assembly is used, the 4/11 regulator must be removed to prevent over-regulation.
LiGhTinG Low heAT fLAme AdjusTmenT using a paper match or a utility lighter, hold a flame over the burners on your lynx accessory feature an adjustable the burner ports while you push and turn the control knob low setting.
CONTACTING LYNX CUTOMER CARE before calling lynx customer care, please make sure you your satisfaction is of the utmost importance to us. if a have the following information: problem cannot be resolved to your satisfaction, please write, fax or email us: • model number...
DAmAgES immEDiAtEly, regardless of you. be sure to hold on to the container for inspection. We extent of damage. cannot assume responsibility for damage or loss incurred in transit. (See iNDEX: “contacting lynx customer care” for further details.) important notes Where’s the Wind? Are You “on-the-LeveL”?
...continued BuiLT-in insTALLATions CLeARAnCe To ComBusTiBLe mATeRiALs lynx built-in accessories are intended for installation in a minimum clearance from the sides and back of the acces- built-in enclosure constructed of non-combustible materials. sory to adjacent combustible construction below the top of unit are 12”...
(See iNDEX: “contacting lynx”.) All installation and all installation parts must conform to local codes with the National Electrical code, ANSi/NfpA it is recommended that any flexible pipe used be kept as 70-1990 and the National fuel gas code, ANSi Z223.1/...
Always shut off the LP-gas supply at the cylinder when the is required a LP gas pressure regulator and hose assembly accessory is not in use. is required and must be the type specified by Lynx. (See INDEX: “Contacting Lynx”.) Cylinders must be stored outdoors in a well-ventilated area out of the reach of children.
Gas & electric connections ...continued LP GAs hook uP nATuRAL GAs/LP BuLk-TAnk hook uP NATURAL GAS HOOK-UP L.P. GAS HOOK-UP LP BULK-TANK HOOK-UP maxImum runs for all applIances on supply lIne WarnIng Run Length Max BTU for all 3/4” Pipe (in feet) Appliances on line COLD WEATHER WARNING: PROPANE 360,000...
3 specialized electrical kits that you may purchase for your accessory, depending upon how it will be installed. Each electrical kit ships with an instructional sheet for assembly. As- sembly instructions and schematics/drawings can also be found on our website at www.lynxgrills.com...
testing the installation Before turning the gas supply on, check for proper installa- Fixing a gas Leak tion using the following test: 1. Shut off the gas supply 1. Plug the transformer back into the receptacle. 2. Turn all grill controls to the “ON” position to purge the 2.
SIDE BURNER SCHEMATICS LsB501 side BuRneR LSB501 Side Burner Light Molex Male Green Female Pins Varistor Molex Female Male pins LEAD WITH PIN DEAD LEAD (NO PIN) Molex Molex Male Female Female Pins BURNER Male pins LsB502 side BuRneR LSB502 Side Burner Light Light Molex Male...
Page 21
SIDE BURNER SCHEMATICS ...continued side BuRneR ConneCToR SEDONA SiDE burNEr AccESSOry cArE & uSE/iNStAllAtiON...
CUT-OUT DIMENSIONS FOR SEDONA BUILT-IN GRILLS & ACCESSORIES note: Side burners may be rotated 90 degrees. CouNtertop NotCh Detail cutOut NOt 0.56” only required if island countertop rEQuirED note: For Natural Gas grills, the manufacturer With liJs overhangs the face of the island recommends using 3/4”...
II. Limited Five-Year Warranty 7) No one has the authority to add to or vary lynx’s the following grill parts are warranted to be free from de- warranty, or to create for lynx any other obligation or fects in material and workmanship, when subjected to normal liability in connection with the sale or use of its products.
SIDE BURNER EXpLODED pARTS LIST ITEM NO. MODEL PART NUMBER DESCRIPTION QTY. LSB501 PAN / BODY WELDMENT LSB502 PAN / BODY WELDMENT LSB501 33921 COVER LSB502 33916 COVER LSB501/2 33827 BATTERY/TRANSFORMER MTG BRACKET LSB501/2 80693 MANIFOLD WELDMENT LSB501 33952 ORIFICE, N.G. LSB502 33952 ORIFICE, N.G.
Need help?
Do you have a question about the Sedona LSB502LP and is the answer not in the manual?
Questions and answers