Page 1
Co., Ltd. assumes no responsibility for injuries or property damage resulting from failures arising out of improper installation or operation inconsistent with this documentation.
Page 2
Caution: Notice: • Before attempting to connect or operate • This product is not suitable for use in loca- this product, please read these instruc- tions where children are likely to be pres- tions carefully. ent. • Do not install this product in locations where ordinary persons can easily reach.
Mass: Approx. 2.0 kg {4.42 lbs} Finish: Main body: Surface treatment steel sheet Decorative cover: ABS resin i-PRO white <WV-QEM506-W> Black <WV-QEM506-B> Precautions for installation In order to prevent injury, the product must be securely mounted to the ceiling according to the Installation Guide.
Installation Refer to the operating instructions of the camera for details on the camera installation (including the camera mounting, cable connection and adjustment). Step 1 Create a ø300 mm {11-13/16 inches} hole. Ceiling surface ø300 mm {11-13/16 inches} Brand logo side Visual reference for the decorative cover Install two anchor bolts (M10: locally procured) into the ceiling.
Page 5
Secure the safety wire angle (accessory) to the anchor bolt (for Step 3 connecting the safety wire), and connect the safety wire (accessory). ①Mount a nut so that the safety wire <Image of safety wire connection> angle is secured on the anchor bolt. ②Remove the safety wire from the safety Existing anchor bolt wire angle.
Page 6
Check the orientation for inserting the mounting chassis into Step 5 the ceiling. To align the i-PRO logo on the decorative cover, align the direction of the mounting chassis before inserting the mounting chassis into the mounting hole on the ceiling board. Mounting hole...
Page 7
Secure the mounting chassis. Step 6 ① ② Anchor bolt (for securing the mounting chassis) Double nuts Ceiling board fixing bracket (locally procured) (4 places) Ceiling board Ceiling board fixing screw ③ (4 places) Ceiling board fixing bracket Ceiling board fixing screw When inserting the mounting chassis...
Page 8
Pull out the camera mounting stage Step 7 ② ② ③ ③ ① ① ① Loosen the screws. ④ ④...
Page 9
Install the attachment plate Step 8 Camera mounting method Recommended tightening torque: 0.78 N·m {0.58 lbf·ft} Attachment plate Fixing screw for attachment plate (accessory) (camera accessory) For Step 9, follow the installation procedure in the camera Step 9 installation section or the installation procedure leaflet. Bit (camera accessory) Recommended tightening torque: 1.2 N·m {0.89 lbf·ft}...
Page 10
Mount the decorative cover. Step 10 ③ ③ ② ② ① ① Hook (4 places) ② ② ① ① Decorative cover protrusions (4 places) Decorative cover...
Page 21
飾りカバーを取り付ける Step10 ③ ③ ② ② ① ① フ ッ ク (4か所) ② ② ① ① 飾りカバー 突起部 推奨締付トルク: (4か所) 飾りカバー Iマーク (4か所) 0.4N·m{4.1kgf·cm} 固定ねじ ③ 推奨締付トルク:0.78N·m{8kgf·cm} 飾りカバー固定ねじで固定可能な位置は、 イラストの位置と反対側の2カ所あります。...