Connect To Electrical Devices - HUSTLER HPGH5500 Instruction Manual

Connect the output terminal of the generating set with the electrical equipment.
Don't start or stop the engine when the electrical equipment is in "ON" status.

Connect to Electrical Devices

Inspect power cord for damage before using. There is a hazard of electric shock
from crushing, cutting or heat damage.
Electric Shock
To reduce the risk of electrical shock, DO NOT use electrical cords that are worn,
frayed, bare or otherwise damaged.
DO NOT touch bare wires of receptacles.
DO NOT handle the generator or electrical cords while standing in water, or
wet conditions.
• Allow the engine to stabilize and warm up for a few minutes after starting.
• Make sure the electrical devices are in "OFF" position and the load current is not
higher than the maximum capacity current of single socket.
If the current of single load is higher than the maximum capacity current of single
socket, please disconnect the load.
If connected devices overheat, turn them off and disconnect them from generator.
Bearing Capacity
DO NOT overload the generating set.
Exceeding the capacity of generator can damage the generator and/or electrical
devices connected to it.
• You must make sure your generator can supply enough rated (running) and surge
(starting) watts for the electrical devices you will power at the same time. Follow
these simple steps to calculate the running and starting watts necessary for
your purposes.
1. Select the electrical devices you will power at the same time.
2. The amount of power you need to run all the devices is the total rated (running)
watts of these items.
22- ENG