Advertisement
4) After successful verification, the voice prompts "Please start
entry". Place your same finger 5 times at the fingerprint reader at
different angles.
5) The green light will be on and the voice prompts "Entry is
successful" if the Fingerprint is registered successfully.
5.3 Setup a Passcode
1) Touching the numeric keypad to wake up the code area.
2) Press the "1" + "#" key, the green light on and the voice prompts
"Please verify the administrator".
3) Authenticate using admin fingerprint or passcode. If no fingerprint
or passcode has been registered, use any fingerprint or the initial
passcode "123456" to verify.
4) After successful verification, the voice prompts "Please start
entry". Enter the passcode you want to set (support 6 to 12 digits
password length) and press the "#" key to end. The passcode entry
needs to be entered twice.
5) The voice prompts "Passcode set successfully", and a Passcode
is successfully set up.
5.4 Restore Factory Default Settings
1) Touching the numeric keypad to wake up the code area.
2) Press the "888" + "#" key, the red light will be on and the voice
prompts "Please verify administrator".
3) Place admin fingerprint or enter admin passcode to verify.
4) The green light will be on and the voice prompt "Restore Factory
Default Settings Successful".
5.5 Forced Factory Reset
1) Press and hold the reset button on the rear handle (the small hole
next to the button) for 8 seconds, the light flashes in red, release it,
7
Hide quick links:
Advertisement
