Siemens SIMATIC RTLS Operating Instructions Manual page 20

Approvals
FCC information
Siemens SIMATIC RTLS PCB OEM AC (6GT2700-8DF10-0AX1);
Contains FCC ID NXWOEMAC
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Caution
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own expense.
Host labelling guidance for the end integrator
This is an advise for host manufacture to provide a physical / e-label on their host product
stating, "Contains FCC ID: NXWOEMAC":
A permanently affixed label must be used. The modular transmitter must be labeled with its
own FCC identification number, and, if the FCC identification number is not visible when the
module is installed inside another device, then the outside of the device into which the
module is installed must also display a label referring to the enclosed module. This exterior
label can use wording such as the following: "Contains Transmitter Module FCC ID:
NXWOEMAC" or "Contains FCC ID: NXWOEMAC". Any similar wording that expresses the same
meaning may be used.
RF Exposure guidance
In order to comply with FCC RF Exposure requirements, this device must be installed to
provide at least 20 mm separation from the human body at all times.
20
Operating Instructions, 02/2023, C79000-G8976-C519-06
SIMATIC RTLS PCB OEM AC