Adjusting The Sound Characteristics; Attenuating The Sound; Changing The Sound And Display Settings - Sony CDX-M750 Operating Instructions Manual

Adjust ing t he sound
charact erist ics
You can adjust the bass, treble, balance, and
fader.
You can store the bass and treble levels
independently for each source.
1
Select the item you w ant to adjust by
pressing (SOUND) repeatedly.
Each time you press (SOUND), the item
changes as follows:
CDX-M 750:
EQ (equalizer) t POS (listening position) t
BAL (left-right) t F (front) t R (rear) t
SUB (subw oofer)
CDX-M 650/ M 600:
BAS (bass) t TRE (treble) t BAL (left-right)
t FAD (front-rear) t SUB (subw oofer)
2
Adjust the selected item by pressing <
or , .
When adjusting with the rotary
commander, press (SOUND) and rotate the
VOL control.
Note
Adjust w it hin t hree seconds af t er select ing t he
it em.
At t enuat ing t he sound
Press (ATT) on the card remote
commander or rotary commander .
"ATT on" appears momentarily.
To restore the previous volume level, press
(ATT) again.
Tip
When t he int erf ace cable of a car t elephone is
connect ed t o t he ATT lead, t he unit decreases t he
volume aut omat ically w hen a t elephone call comes
in (Telephone ATT f unct ion).
26
Downloaded from: https://www.usersmanualguide.com/
Changing t he sound and
display set t ings
The following items can be set:
Set (Set t ing)
•Clock (page 9)
•Beep — to turn the beeps on or off.
•RM (Rotary Commander) — to change the
operative direction of the controls of the
rotary commander.
— Select "norm" to use the rotary
commander as the factory-set position.
— Select "rev" when you mount the rotary
commander on the right side of the
steering column.
•English/French/Spanish — to change the
display language to English, French, or
Spanish.
Dis (Display)
•D.Info (Dual Information) — to display the
clock and the play mode at the same time (on)
or to display the information alternately (off).
•SA (Spectrum Analyzer) — to change the
display pattern of the equalizer display
(page 28).
•Dimmer — to change the brightness of the
display (When the illumination cord
connected).
— Select "Auto" to dim the display only
when you turn the lights on.
— Select "on" to dim the display.
— Select "off" to deactivate Dimmer.
•Contrast — to adjust the contrast if the
indications in the display are not
recognizable because of the unit's installed
position.
•M.Dspl (Motion Display) — to turn the
motion display on or off.
•A.Scrl (Auto Scroll) (page 11)