Panasonic Panduan NU-MX100P Operating Instructions Manual page 7

Cut off the power supply and rest the solution in the tank
for 30 mins. Pour it out, rinse the tank thoroughly and dry.
When using white vinegar: Dilute 30 ml of white vinegar
with 120 ml of cold water, pour the solution into the
water storage tank of the base，press "Power", press
"Reheating/Steam", and let the product work for 1-2 mins.
Cut off the power supply and rest the solution in the tank
for 30 mins. Pour it out, rinse the tank thoroughly and dry.
● Cleaning air filter
The filter at the bottom of the base can be removed for
cleaning. After cleaning, re-install it on the base with the
silver side outward.
Before using citric acid, read the instructions
carefully. Do not touch eyes. Place it beyond
the reach of children.
6. Q & A
(1) What items can be put into the product for sterilization?
Generally, items that can withstand high temperature
above 100 °C and release no hazardous substance
after being heated can be sterilized (for details, refer to
the instructions of these items or consult professionals),
such as PP bottle, glass bottle, silicone bottle, pacifier,
teether, safe tableware made of safe materials.
(2) Is there any strict requirements for water quality?
Generally, for sterilization, purified water or treated
drinking water is recommended. Untreated tap water
has a lot of impurities and is more likely to produce
scale. This will increase the cleaning difficulty and may
affect the normal operation of the product.
(3) Why is the sterilization time too short?
The reason why the sterilization time is too short may be
the water added is too little. Generally, the recommended
minimum amount of water to be added is about 90 ml. It is
appropriate to maintain a sterilization time of 10-15 minutes.
(4) Why are there still water droplets on some items after
drying?
The drying effect will be affected if too many items are placed
or items are placed too densely or at improper angles. It
is recommended to sterilize and dry items in batches, or
appropriately increase the drying duration and frequency.
(5) Why are there still water drops on the inner wall of
Body (near the overlap between Lid and Body) after
drying cycle completes?
During the drying process, the water steam condenses
into water drops trapped in the overlap between Lid and
Body, and can't be fully dried up. When Lid is opened,
some water drops slide down the inner wall of Body from
the overlap. The water condensation can be reduced by
longer drying duration.
Eng-6