Advertisement
REPLACEMENT COMPONENTS
Vertical Tube Assembly
No Holes Base
1 Telescoping Rod
425-3085
Hex Key
(2) Hex Head
425-3379
Cap Screws &
(2) Lock Washers
JOTTO DESK ACCESSORIES
Specifications subject to change without notice
PIVOTING CELL PHONE HOLDER
Model 425-5299
12" flexible wand with blue LED's and
Allows
you
to
tilt
your
phone
rheostat to adjust brightness. Three
independent of the desktop angle.
foot power cord plugs into cigarette
Mounts to side of 10" x 12" Desktop.
BRACE KIT
Model 425-5238
The Brace Kit attaches to the stand
Illuminating quick-note pad. Hand
providing additional support. It can
held for convenience. Illuminates in
be adjusted in length and mounts to
Red or Amber. Removable mounting
flat, vertical or angled surfaces.
options. Jot notes down, day or night...
Articulated
1 Tube &
Swing Arm
425-1188
425-5342
Ratchet
Handle
425-1273
425-3385
USB LIGHT
KENSINGTON® MASTERLOCK®
Model 425-1317
Model 425-2490
Computer securing system uses
Kensington locking system. Fasten
security
cable
structure in vehicle.
lighter.
SCREEN SUPPORT
GLO-WRITER™
Model 425-5999
Model 425-3500
The Screen Support is designed
to keep your screen in place while
you use your computer. It attaches
directly to the desk and adjusts in
height and tilt angle.
anywhere!
WARNING: Do not install or use this product in any manner which would interfere
with any of the vehicles controls, air bags or safety devices. Follow vehicle owner's
manual instructions should a dash warning light come on after installation of this desk.
Do not install or use this product in any manner which causes a safety hazard for
vehicle and/or occupants.
To avoid serious injury do not place this desk or any objects between the air bags
and yourself or any passengers. If necessary remove the desk before driving. Store
in trunk or other safe place.
We recommend that you do not work on the Jotto Desk while driving!
to
permanent
'99-'14 FORD E-SERIES VAN
PLEASE CHECK ALL BOX
FLAPS AND INSERTS
FOR PARTS STORED
UNDERNEATH BEFORE
DISCARDING BOX.
THANK YOU.
Park safely, then use. Remember, driving safely comes first.
WARNING: Make sure of and check on a regular basis that all knobs, fastening
devices and handles are tight and secure. Repair or replace any faulty or worn
parts. All equipment, such as computers, printers, phones, etc. must be safely
secured when vehicle is in motion.
DISCLAIMER: The manufacturer of this product may not be held liable for
any accidents, injuries or problems caused by the use or installation of this
product.
Specifications subject to change without notice.
Jotto Desk® is a patented product and registered trademark of Assembled Products® Corporation
425-5324II 10/15
Computer Mount - No Holes
425-5324
Advertisement
Table of Contents
Related Manuals for Jotto Desk E Series
Summary of Contents for Jotto Desk E Series
- Page 1 Allows tilt your phone We recommend that you do not work on the Jotto Desk while driving! Kensington locking system. Fasten rheostat to adjust brightness. Three independent of the desktop angle. Park safely, then use. Remember, driving safely comes first.
- Page 2 INSTALLATION PROCEDURE STAND ASSEMBLY OPERATION READ INSTRUCTIONS BEFORE BEGINNING INSTALLATION 1. Remove Hex Head Cap Screws from stand assembly and place tube over the No-Holes Mount Base. 2. Thread (2) Hex Head Cap Screws with (2) Lock Washers through tube and into front and rear of No Holes Mount post at bottom of tube.
Need help?
Do you have a question about the E Series and is the answer not in the manual?
Questions and answers