Nortel Ethernet Routing Switch 2500 Series; Nn47215-505 (323165-B) 02.01 Standard - Nortel 2526T Configuration

38 Configuring Security using the CLI
password security command
The password security command enables password security on the
switch.
The syntax for the command is:
password security
The password security command has no parameters or variables.
no password security command
The no password security command disables password security on
the switch.
The syntax for the command is:
no password security
The no password security command has no parameters or variables.
show password security command
The show password security command displays the current status
of password security on the switch.
The syntax for the command is:
show password security
The following shows a sample output for this command:
2550T (config)#show password security
Password security is enabled
The show password security command has no parameters or
variables.
password aging-time day command
The password aging-time day command sets the password aging
time. Password security must be enabled for the command to be available.
The syntax of the command is:
password aging-time <aging-value>
where <aging-value> is between 0 - 2730. A value of 0 causes the password
to age out immediately.
If a new aging time is set from the CLI, the password aging counters are
not reset.
Copyright © 2007, Nortel Networks
.

Nortel Ethernet Routing Switch 2500 Series

Security — Configuration and Management

NN47215-505 (323165-B) 02.01 Standard

4.1 19 November 2007