Table of Contents
Advertisement
5
INITIAL INSTALLATION & OPERATION
General
The filter assembly is protectively packed with all parts assembled.
Installation
1. Remove the filter assembly from the wooden pallet.
2. Connect the filter assembly to the inlet and outlet lines.
3. Connect drain line to the outlet of the flushing valves; the line should not constrain the
flushing water flow. As a result the drain line diameter should be at least the diameter
of the flushing valve and not longer than 5 m (17 feet). Verify that water runs freely
out of the drain pipe.
4. Check that all connections are properly secured.
5. Check that all nuts and bolts on the filter periphery are properly tightened and
secured.
6. Set up the control unit according to its operation manual.
F
ILTRATION
Figure 2: Initial Filter Installation
5960 Marion Dr. Denver, CO 80216 USA, Tel. +1 720 201 5637;
mkraft@profloinc.com; www.profloinc.com
S
YSTEMS
Page 7 of 22
Advertisement
Table of Contents
