Wlan Internet Access Points - Nokia N95 8GB User Manual

Select Options Advanced settings
>
following settings:
Network type — Select the internet protocol type
●
to transfer data to and from your device. The other
settings depend on the selected network type.
Phone IP address (for IPV4 only) — Enter the IP
●
address of your device.
DNS address — Enter the IP addresses of the
●
primary and secondary DNS servers, if required by
your service provider. Contact your internet service
provider to obtain these addresses.
Proxy server address
●
proxy server.
Proxy port number
●
the proxy server.

WLAN internet access points

Press , and select Tools
Connection Access points
>
New access point.
Follow the instructions from the WLAN service
provider.
WLAN network name
●
Search for networks. If you select an existing
network, WLAN network mode
security mode are determined by the settings of its
access point device.
Network status — Define whether the network
●
name is displayed.
to change the
— Enter the address of the
— Enter the port number of
Settings
> >
Options Edit
> >
— Select Enter manually
and WLAN
WLAN network mode
●
an ad hoc network and to allow devices to send and
receive data directly; a WLAN access point device is
not needed. In an ad hoc network, all devices must
use the same WLAN network
WLAN security mode
●
used: WEP, 802.1x
WPA/WPA2. If you select
encryption is used. The WEP, 802.1x, and WPA
functions can be used only if the network supports
them.
To enter the settings for the selected security mode,
select WLAN security
Security settings for WEP
WEP key in use
●
privacy (WEP) key number. You can create up to four
WEP keys. The same settings must be entered on the
WLAN access point device.
or
Authentication type
●
the authentication type between your device and
the WLAN access point device.
WEP key settings
●
or
of the key), WEP key format (ASCII
Hexadecimal), and
the selected format).
Security settings for 802.1x and WPA/WPA2
WPA/WPA2 — Select the means of authentication:
●
EAP to use an extensible authentication protocol
— Select Ad-hoc
name.
— Select the encryption
(not for ad hoc networks), or
Open network, no
settings.
— Select the wired equivalent
— Select Open or Shared
— Enter WEP encryption
or
WEP key (the WEP key data in
to create
for
(length
143