Paper Refill; Preventive Maintenance; Batteries - FLOWBIRD CWT Compact S4 Touch Installation & Maintenance Manual

Daily operation
box must be emptied as described in section 2 above before the knob can be
returned to the correct position.
3. Close the vault door. The opening knob must be in the vertical position for the
door to be closed.
6.2

Paper refill

Raise the print head and remove the remaining paper, if any.
Install new paper roll as described in section
7

Preventive maintenance

This chapter primarily describes preventive maintenance activities. How often
these activities need to be carried out depends, to a large extent, on the
conditions of the area where the ticket terminals have been installed. The thermal
head, for instance, must be cleaned more frequently if the surrounding air contains
a high concentration of diesel exhaust fumes.
Note:
Spare part numbers can be found on the exploded view drawings of each
models.
7.1

Batteries

Battery levels
The CWT C can send battery measurements of the battery voltage to WebOffice
for monitoring.
The CWT will send the battery voltage measured during regular intervals to
WebOffice
The warning and error levels can be set but are default set to:
·
Warning = 11.9 V
·
Error = 11.5 V
When the CWT has sent a warning; e.g. due to a power down; the terminal will
send a recovery event to WebOffice when the battery is charged to its normal
level again.
If a Warning is sent and no recovery event is sent within a day, it may be time to
change the battery
Issue 3 CWT Compact S4 Touch Installation & Maintenance Manual for CWT 1.0-0
Loading paper in a GeBe printer .
61
Page 65