Connection Settings - Nokia N90 User Manual

Anykey answer—Select On, and you can answer an
incoming call by briefly pressing any keypad key, except
, , , and
Line in use ( )—This setting is shown only if the SIM card
supports two subscriber numbers, that is, two phone lines.
Select which phone line you want to use for making calls
and sending text messages. Calls on both lines can be
answered irrespective of the selected line. If you select
Line 2 and have not subscribed to this network service, you
will not be able to make calls. When line 2 is selected,
is shown in the standby mode.
Tip! To switch between the phone lines, press and
hold in the standby mode.
Line change ( )—To prevent line selection, select
change > Disable
this setting, you need the PIN2 code.

Connection settings

Data connections and access points
Your phone supports packet data connections ( ), such as
GPRS in the GSM network.
Glossary: General packet radio service (GPRS) uses
packet data technology where information is sent in
short packets of data over the mobile network.
94
.
if supported by your SIM card. To change
To establish a data connection, an access point is required.
You can define different kinds of access points, such as:
• MMS access point to send and receive multimedia
messages
• Access point for the Web application to view WML or
XHTML pages
• Internet access point (IAP) to send and receive e-mail
Check the type of access point you need with your service
provider for the service you wish to access. For availability
and subscription to packet data connection services, contact
your network operator or service provider.
Packet data connections in GSM and
UMTS networks
Line
When you use your phone in GSM and UMTS networks,
multiple data connections can be active at the same time
and access points can share a data connection. In the
UMTS network, data connections remain active during
voice calls. To check the active data connections, see
"Connection manager‚" p. 81.
The following indicators may be displayed below the signal
indicator, depending on which network you use:
GSM network, packet data is available in the network.
GSM network, packet data connection is active, data
is being transferred.