Advertisement
Step 3. Connect AC End Cable
A) Installation of cable end connector.
Solid wrench No.30 or monkey wrench wide than 3cm 、
Cross screwdriver No.1、Wire striper.
a). Disassemble the connector and thread the cable through
the waterproof cap and connector housing
b).Connect the cable to the terminal, and the screw torque
is 0.8 + / - 0.1N · m
c). Push Housing into Body
d). Insert Seal and Clamp Finger into body, then tighten the
nut, torque 2.5+/-0.5N·m
e). Installation of cable end male connector is the same as
female connector
Note: An electrical test should be done, to ensure that the connector has been installed correctly.
B) Connect the AC end cable with the AC branch circuit
a).Mating male and female connector: Push the plug into
the socket completely, then rotate the locker according to
the direction instructed by the marks on the locker
3
Advertisement
