Wlan Internet Access Points - Nokia E55 User Manual

Access point name — The access point name is provided
•
by your service provider.
User name — The user name may be needed to make a
•
data connection, and is usually provided by your service
provider.
Prompt password — If you want to set the device to ask
•
for a password every time you log in to a server, or if you
do not want to save your password in the device, select
Yes.
Password — A password may be needed to make a data
•
connection and is usually provided by your service
provider.
Authentication — Select
•
password encrypted or
encrypted when possible.
Homepage — Depending on the access point type you
•
are setting up, enter the web address or the address of the
multimedia message centre.
Use access point — Select
•
device to ask for confirmation before the connection using
this access point is created, or
device to connect to the destination using this access point
automatically.
Select Options Advanced settings
>
following:
Network type — Select the internet protocol type to
•
transfer data to and from your device. The other settings
depend on the selected network type.
Phone IP address (for IPv4 only) — Enter the IP address
•
of your device.
DNS addresses — Enter the IP addresses of the primary
•
and secondary DNS servers, if required by your service
142
Secure to always send your
Normal to send your password
After confirmation
Automatically to set the
and from the
provider. To obtain these addresses, contact your internet
service provider.
Proxy server address
•
server.
Proxy port number
•
server.

WLAN internet access points

Select Menu
Destinations
on the display. Or, open one of the access point groups, select
an access point marked with
Use the instructions provided by your service provider to edit
the following:
WLAN network name
•
Search for
WLAN network mode
to set the
determined by the settings of its access point device.
Network status
•
displayed.
WLAN network mode
•
hoc network, and to allow devices to send and receive data
directly; a WLAN access point device is not needed. In an
ad hoc network, all devices must use the same WLAN
network name.
WLAN security mode
•
WEP, 802.1x, or WPA/WPA2. (802.1x and WPA/WPA2 are
not available for ad hoc networks.) If you select
network, no encryption is used. The WEP, 802.1x, and
WPA functions can be used only if the network supports
them.
— Enter the address of the proxy
— Enter the port number of the proxy
Ctrl. panel Settings
> >
Access point, and follow the instructions
>
, and select Edit.
— Select Enter manually
networks. If you select an existing network,
and WLAN security mode
— Define whether the network name is
— Select Ad-hoc
— Select the encryption used:
© 2010 Nokia. All rights reserved.
and Connection
>
or
are
to create an ad
Open