Mounting Your Safe - Vaultek SLIDER Instruction Manual

Securing Your Safe
Installing Mounting Bracket
TIP: Your safe can install on the mounting plate from the left or right side. When installing the plate, be sure the
bottom is parallel to the floor (Fig P) so the safe opens horizontally. Angling the plate or aiming the safe downwards
can affect the rail mechanics and prevent safe from opening correctly.
Locate mounting surface, making sure the safe will have enough clearance to open properly prior to installing.
Hold mounting plate in place and use a pencil to mark desired hole locations. Drill 7/32" inch pilot holes.
Using hardware provided fasten mounting plate in place and tighten firmly.
Mounting Safe
Locate the 4 receiving slots located on the safe sides, and the 4 tabs located on the mounting plate.
Fully insert the tabs on the mounting plate into the receiving slots on the safe (Figure N/O), and press the safe
downwards to lock in place (Figure P).
FIGURE N
21 Vaultek
®
FIGURE O FIGURE P
To Remove Safe from Mounting Plate
Open the safe. Locate the release clip on the same side as the attached mounting plate.
Use your thumb or finger to pull the release clip back, and lift the safe off the mount at the same time (see
FIGURE Q/R). The safe will not remove without pulling the release clip back.
FIGURE Q
Aftermarket Configuration
Your mounting plate features additional pre-drilled holes for the addition of aftermarket brackets or
modifications (see Figure 1.4 on page 20) using VESA standard fitment. This is great if the environment
requires the safe to be configured in a certain manner beyond the standard mounting options available.
For tutorials, setup help, and FAQs visit www.vaulteksafe.com/setup/ and select your safe.
FIGURE R
22 Vaultek
®