Answer Or Reject A Call - Nokia 8800 Sirocco User Manual

C a l l f u n c t i o n s
Voice commands are language-dependent. To set the language, see
Voice playback language in "Phone," p. 63.
If an application is sending or receiving data using a packet data
connection in GSM, end the application before you use voice dialing.
1. In the standby mode, press and hold the right selection key. A short
tone is played, and Speak now is displayed.
If you are using a compatible headset with the headset key, press and
hold the headset key to start the voice dialing.
2. Say the voice command clearly. If the voice recognition is successful,
a list with matches is shown. The phone plays the voice command of
the match on the top of the list. After about 1.5 seconds, the phone
dials the number. If the result was not the correct one, select
manually another entry from the list.
Note: Using voice tags may be difficult in a noisy environment or
during an emergency, so you should not rely solely upon voice dialing in
all circumstances.
Using voice commands to carry out a selected phone function is similar
to voice dialing. See "Voice commands," p. 57.

■ Answer or reject a call

To answer an incoming call, press the call key, or open the slide. To end
the call, press the end key, or close the slide.
To reject an incoming call when the slide is open, press the end key.
To mute the ringing tone, select Silence. Then answer or reject the call.
Tip: If the Divert if busy function is activated to divert the calls
(for example, to your voice mailbox), rejecting an incoming call
also divert the call. See "Call," p. 62.
If a compatible headset supplied with the headset key is connected to
the phone, press the headset key to answer and end a call.
24