Advertisement
Installation
Mounting 2/3
Route the building-side cable through the hole in the
center of the mount plate.
On the bottom edge of the device, loosen the T10 Torx
Security screws and remove the faceplate.
On the rear of the device, loosen the four T10 Torx
Security screws on the cable bay door to access the
ethernet and I/O ports.
Insert the RJ-45 ethernet cable through the right
grommet using the included grommet punch and
pass through the cable bay door before plugging
into the ethernet port.
If needed, insert I/O wires through the left grommet
and pass through the cable bay door before
plugging into the I/O terminal block. Remove the I/O
terminal block with a flat head screwdriver for easier
installation.
Attach wires according to the pins below.
Pin 1
Pin 2
NO
COM
9
Pin 3
Pin 4
Pin 5
NC
GND
B
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
sales@verkada.com
Pin 6
Pin 7
Pin 8
A
12V
GND
Pin 9
Pin 10
IN 1
IN 2
All specifications are subject to change without notice
Copyright © 2022 Verkada Inc. All rights reserved.
Advertisement
