Advertisement
Installation
Mounting 1/3
The Flush Mount Plate has holes configured for
the following mounting conditions:
A) Legacy intercom back box
B) Direct wall mounting
C) 4-gang Junction box mounting
Use the corresponding holes to mount to an
existing intercom back box (A) or 4-gang
junction box (C).
To mount directly to a wall, use the mount
plate as a template to mark mounting holes
(B) and the center cutout. Use the marks to
drill pilot holes for the mount plate. For direct
mounting, drill 3mm pilot holes. When using
wall anchors, drill 6mm pilot holes.
Use the supplied screws to install the mount
plate onto the wall. Ensure that the labels on
the mount plate are facing away from the
wall.
Please Note The supplied screws are
intended to cover most possible install
cases. Be sure to use the best screws
for your specific job.
8
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
sales@verkada.com
All specifications are subject to change without notice
Copyright © 2022 Verkada Inc. All rights reserved.
Advertisement
