NEILPRYDE FLY 1.4 User Manual page 4

Instructions to inflate your wing
Strut valve
Always pump the Strut
first, before than the
Leading Edge valve.
Leading
edge valve
3
- Make sure that the valve is correctly positioned, by twisting it and
pulling it up. Connect the pump to the valve to open it
4
- Pump the leading edge accordingly the pressure values specified for
each model (see page 4)
Any use of an air compressor may result in poor performance or damage to the wing, and
automatically avoids all warranties. If you leave your wing exposed to the hot sun, check the
pressure and deflate it slightly. Otherwise the wing may become over inflated and stretch the
material. The ambient temperature affects the tube's internal pressure: a variation of 1° C/ 1.8° F
causes a variation of the pressure in the tube of +/- 0.06psi (4 mBar).
1
- Make sure that the valve is correctly
positioned, by twisting it and pulling it
up. Connect the pump to the valve to
open it
2
- Pump the strut accordingly the
pressure values specified for each model
(see page 4)
5