Advertisement
Quick Links
Advertisement
Related Manuals for NEILPRYDE FLY 1.4
Summary of Contents for NEILPRYDE FLY 1.4
- Page 1 User Manual...
- Page 2 ARE FOR YOUR SAFETY AND PROTECTION. THIS INFORMATION MAY BE SUBJECT TO CHANGE AT ANY TIME. PLEASE VISIT OUR WEBSITE AT: WWW.NEILPRYDE.COM CURRENT UPDATES. IF YOU ARE BELOW THE AGE OF 18, YOU SHOULD HAVE YOUR PARENT OR GUARDIAN READ THESE WARNINGS AND...
- Page 3 Make sure to attach the twist pump adapter (in blue) to correctly inflate LE inflation Strut inflation the wing pressure (PSI) pressure (PSI) Model FLY 1.4 10.0 10.0 FLY 1.8 10.0 10.0 FLY 2.1 FLY 2.5 FLY 2.9 FLY 3.3 FLY 3.6...
- Page 4 Instructions to inflate your wing Strut valve Always pump the Strut first, before than the Leading Edge valve. - Make sure that the valve is correctly positioned, by twisting it and pulling it up. Connect the pump to the valve to open it - Pump the strut accordingly the pressure values specified for each model...
- Page 5 • IF any products are found to show signs of wear and tear these should be repaired or replaced immediately and before further use. If in doubt about any signs of wear and tear, please contact your local NeilPryde ONE-DESIGN vendor. Contact details are available from www.neilpryde.com.
- Page 6 • As you learn the sport, work within your own limitations and do not exceed them. • Make sure to stay hydrated. This is a physically demanding sport and dehydration can also occur in cold temperatures. • Do not alter, modify or change this product. •...
- Page 7 How to attach the leash INSTRUCTIONS The leash has one side with a short loop plus the swivel (on the left), and the other side with a bigger loop (on the left). The short loop needs to be attached either to the wrist cuff or the waist belt, depending how you like to use your leash.
- Page 8 - On the other side, push the bigger loop through the attachment point of the wing - Push the wrist band or waist belt through the loop - Make sure to pull it as tight as possible, making a node...
- Page 9 Instructions to deflate your wing - After using the wing, whenever possible, rinse it with fresh water - Find the LE valve, push its pin down and twist it. The air will start flow to the outside - Find the strut valve, push its pin down and twist it, the same way it was done for the LE valve...
- Page 10 Instructions to fold your wing - Flip the wing over, so the handles are down - Fold the wing in half at the strut, so the handles are sticking out - Fold both trailing edges forward - position the crease line just after the mini battens end - Roll from wingtips to center strut - Fold it in half between the handles to...
- Page 11 Repair instructions - removing the valve - Make sure that the wing is rinsed, dry and deflated before starting the repair. - Use the key provided in the repair kit to remove the valve. - Turn the key anti-clockwise direction, until the valve is completely out of the thread.
- Page 12 Repair instructions - Bladder anti-twist system Removing bladder anti-twist system Press the inner clear plastic part through the black outside part (sewed on the LE) with your thumb. Do this on the left and right side of the LE. INSERTing bladder anti-twist system - Position inner part right under the black part and aling the little notch of both parts...
-
Page 13: Limited Warranty
For customer Limited Warranty claims, proof of purchase from an authorized NeilPryde vendor is required. If the date of purchase cannot be established, NeilPryde will make a determination based upon on the last production year of the particular model, or on the condition of the equipment claimed.