Table of Contents
Advertisement
Glossary
Jumper Moveable direct electrical
connection between two points.
Mainframe Logic Analyzer A
logic analyzer that resides on one or
more board assemblies installed in
an HP 16500B/C, 1660xA, or 16700A
mainframe.
Male-to-male Header A board as-
sembly that makes point-to-point
connections between the female pins
of a flexible adapter or transition
board and the female pins of an
analysis probe.
Preprocessor Interface See
Analysis Probe.
Preprocessor Probe See Analysis
Probe.
Probe adapter See Elastomeric
Probe Adapter.
Processor Probe See Emulation
Probe and Emulation Module.
Prototype Analyzer The
HP 16505A prototype analyzer acts
as an analysis and display processor
for the HP 16500B/C logic analysis
system. It provides a windowed in-
terface and powerful analysis
capabilities.
Glossary-2
Setup Assistant A software pro-
gram that guides you through the
process of connecting and configur-
ing an analysis probe and logic
analyzer to make measurements on a
specific microprocessor.
Shunt Connector. See Jumper.
Stand-alone Logic Analyzer A
stand-alone logic analyzer has a pre-
defined set of hardware components
which provide a specific set of capa-
bilities. It is designed to perform
logic analysis. A stand-alone logic
analyzer differs from a mainframe
logic analyzer in that it does not of-
fer card slots for installation of
additional capabilities, and its specifi-
cations are not modified based upon
selection from a set of optional hard-
ware boards that might be installed
within its frame.
Transition Board A board assem-
bly that obtains signals connected to
one side and re-arranges them in a
different order for delivery at the
other side of the board.
1/4-Flexible Adapter An adapter
that obtains one-quarter of the sig-
nals from an elastomeric probe
adapter (one side of a target micro-
processor) and makes them available
for probing.
Advertisement
Table of Contents
