Table of Contents
Advertisement
Installing a Stealth Acoustics invisible speaker into new construction is compatible with standard speaker
installation (without a back box), as well as installations with the recommended BX, MBX and MBA back boxes.
1: ADD FRAMING
Cross member framing should be
added above and below the speaker
opening whenever possible so that the
speaker and surrounding wallboard
may be securely attached on all four
sides.
(See page 10)
4: ADD INSULATION
Each of the back box models comes
with insulation. For installations without
a back box, it is recommended to
add insulation behind the speaker for
added isolation and performance.
PREPARING FOR NEW CONSTRUCTION
2: BACK BOX
Back boxes are recommended for
every installation.
model back boxes are installed along
with the speaker while MBA and MBX
back boxes are installed flush with the
framing at this time.
See the instructions included with
each back box for proper installation.
5: PLACESAVER™
Install the optional PlaceSaver as a
placeholder for the speaker during the
wallboard installation process.
Adding PlaceSavers will also reveal
where additional support framing may
be necessary.
Center the temporary PlaceSaver on
the framing and attach with provided
hardware.
3: PREPARE WIRING
(See page 9)
BX
securely to the studs at each speaker
location.
6: WALLBOARD
size space for the speaker during the
wallboard installation preventing the
speaker panel itself from exposure to
harsh construction environment.
to "Test Fit & Shims."
Run the speaker wiring and attach it
For runs of 50 feet (15m) or less,
use 16 gauge wire.
For runs longer than 50 feet (15m),
use 14 gauge wire.
The PlaceSaver reserves the exact
After wallboard installation, proceed
(See page 13)
11
Advertisement
Table of Contents
