International Prefix; Data Or Fax Calls - Nokia 6155 User Manual

Access no.+ phone no.+ card
Dial the access number, the phone
number, then the card number (and
the PIN, if required).
Access no.+ card no.+ phone
Dial the access number, the card
number (and the PIN, if required),
then the phone number.
Prefix+ phone no.+ card
the prefix (numbers that must
precede the phone number) and
phone number you want to dial,
then the card number (and the PIN,
if required).
4. Enter the required information
(access number or prefix and card
number), and select
your entries.
5. Select Card name, enter the card
name, and select OK.
Make calls
After you have saved your calling card
information in your device, you can
make a call using your calling card.
1. In standby mode, select
Settings > Call >
2. Enter your security code, and select
OK. See "Security
3. Select your desired calling card.
4. Press the end key to return to
standby mode; then enter the
phone number, including any prefix
(such as 0 or 1) that your calling
card may require when you make a
Copyright © 2005 Nokia. All rights reserved.
no.—
no.—
no.—Dial
OK to confirm
Menu >
Calling card.
settings", p. 55.
calling card call. See your calling
card for instructions
5. Press and hold the call key for a few
seconds until Card call
6. When you hear the tone or system
message, select OK.

International prefix

You can store an international dialling
prefix into your device. In standby
mode, select Menu >
International prefix.
In standby mode, when you enter +
(press * twice) at the beginning of a
phone number, your device
automatically inserts the international
dialling prefix that you have stored
after you press the call key. See
dialling codes", p. 23.

Data or fax calls

Data and fax calling is a network
service. See "Network
If your wireless service provider or
network operator supports this feature,
you can set up the device to send or
receive data and fax calls with a
terminal, such as a PDA or PC,
connected.
For better performance during data
calls, place the device on a stationary
surface. Do not move the device by
holding it in your hand during a data
call.
S e t t i n g s
is displayed.
Settings > Call >
"Insert
services", p. viii.
49