EAW MKC Series Instructions Manual page 7

MKC Series
v. WARNING HEAVY LIFTING, MULTIPLE PERSON LIFT – Lift the MKC Series
Loudspeaker to align the loudspeaker's center threaded mounting hole with the
MKC Series U-Bracket preferred mounting point.
vi. Using a 6mm Allen wrench, loosely thread the screws and washers (B, C & D) through
the MKC Series U-Bracket mounting point, through the selected rubber washer (E) and
into the loudspeaker's center threaded mounting hole. Repeat for the opposite side.
vii. Do to the MKC Series U-bracket's slotted mounting point "A", the hardware may be
preassembled to the MKC Series Loudspeaker.
1. Note, if using the slotted mounting point, the MKC Series U-Bracket must be installed
oriented with the slot angled upward, opposing the ground.
2. Note, for weather protected applications (using MKC-WP Series Loudspeakers), apply
user-supplied, waterproof, non-hardening, non-locking thread sealant to the threads of
two button head screws (B) per the thread sealant's instructions. Failure to do so could
result in water ingress and damage to the loudspeaker.
3. Onto each of two button head screws (B), place a split-lock washer (C), a flat
washer (D) and the selected rubber washer (E). Thread these screws and related
hardware three complete turns into the loudspeaker's two threaded mounting
holes.
4. Leave as large a space as possible between the rubber washer (E) and the flat
washer (D).
5. WARNING HEAVY LIFTING, MULTIPLE PERSON LIFT – Lift the MKC Series
Loudspeaker into the MKC Series U-bracket slots with the large rubber washers (E)
inside the u-bracket and the flat and lock washers (C & D) outside the u-bracket.
viii. Position the MKC Series Loudspeaker to the desired angle.
ix. In securing the angle using the angle locking point, align the MKC Series
Loudspeaker to desired angle.
1. Note, for weather protected applications (using MKC-WP Series Loudspeakers), apply
user-supplied, waterproof, non-hardening, non-locking thread sealant to the threads
of a button head screw (B) per the thread sealant's instructions. Failure to do so could
result in water ingress and damage to the loudspeaker.
2. Onto a socket head screw (F), place a lock washer (H) and a flat washer (G).
3. Using a 3mm Allen wrench, loosely thread the screw and washers (F, G, & H)
through the MKC Series U-Bracket angle lock point and into the loudspeaker's
center threaded mounting hole.
x. Using a 3mm & 6mm Allen wrenches, tighten all screws (B & F).
5. Review the MKC Series Loudspeaker installation
a. Confirm the loudspeaker is level or plumb depending on the configuration.
b. Confirm the aim angle is as expected.
U-Bracket Instructions
Tel 800 992 5013 / +1 508 234 6158
|
www.eaw.com
7