Do you have a question about the HQZZ-260 and is the answer not in the manual?
Questions and answers
Lori Davis
February 26, 2025
Could you please tell me how to reset the filter light I put a brand new filter in I unplugged it and I cleaned it all up and then I plugged it back in and the filter light was still on. I did try the pressing whole power button, but it just shuts it off And does not reset the light.
2 comments:
Therese
February 26, 2025
@Lori Davis press the timer button for 3 seconds
Mr. Anderson
May 14, 2025
To reset the filter light on a Tailulu HQZZ-260 after replacing the filter, hold down the button for 3 seconds until the light turns off.
This answer is automatically generated
Sandy Williams
February 21, 2025
How do I reset the filter when there is no filter button reset
2 comments:
Therese Rachal
February 26, 2025
@Sandy Williams press the timer button for 3 seconds
Mr. Anderson
May 14, 2025
To reset the filter on the Tailulu HQZZ-260, press and hold the button that blinks when the filter screen expires for 3 seconds after replacing the filter. The light will turn off, indicating the reset is complete.
This answer is automatically generated
Sharon
February 11, 2025
resetting the filter light
2 comments:
Mr. Anderson
February 11, 2025
To reset the filter light on a Tailulu HQZZ-260 air purifier, hold down the button for 3 seconds after replacing the filter. The light will turn off, indicating the reset is complete.
This answer is automatically generated
Therese
February 26, 2025
@Sharon press the timer button for 3 seconds
April
May 4, 2025
How do I turn the filter light off after I replaced the filter?
Page 1
User's Manual of Air Purifier True HEPA Filter 3- Stage Filtration System Low Noise Level Child Lock Model: HQZZ-260...
Page 3
CUSTOMER SERVICE Our customer service team is standing by to assist you if you have any questions or concerns. www.tailulu.com support@tailulu.com 1-833-368-8825...
CONTENT Product introduction ---------------------------------------- --------------------------------------- Picture of the product ------------------------------------- Preparation before use -------------------------------- Control panel and functionse ----------------------------------------- Name of each part --------------------------------------------- Method of use ----------------------------------------------- Maintenance ---------------------------------------------- Specifications ----------------------------------- Matters needing attention ----------------------------- Analysis of common problemse...
Product introduction Dear users, thank you tor choosing Tailulu air purifier. Please read this instruction manual before using the product to ensure its safety and convenience of use. HQZZ-260 air purifier efficiently improves air purity by absorbing, decomposing, or transforming various air contaminants. Tailulu air purifier with its distinct visual design provides users with an aesthetic experience.
BEFORE USING THE APPLIANCE 1. Unpack the appliance, remove packing tape and filter protec- tive bag before using the appliance. Install the filter in the unit. Insert the cover into the fixing grooves and close the cover. 2. Place the air purifier at least 1ft/30cm away from the wall or furniture.
Method of use 6 1. ON/OFF key: After the power is turned on, press once, the value will be displayed in the middle,and it will operate at 2F level. 2. Manual mode: Press once to manually adjust the air speed from level 1 to 3.
Maintenance Always unplug the power before any maintenance! 1. Reference time for daily cleaning and maintenance of filter: about once a month. The surface of the filter can only be cleaned with a brush and dry cotton cloth. It is not allowed to wash the filter with water or detergent.
Matters needing attention 1. It is not allowed to wash or spill the product with liquid. 2. Do not put your hands or foreign matters into the air inlet and outlet since there is a high-speed wind wheel rotating in the purifier 3.
Analysis of common problemse 10 Phenomenon Cause and solutions The filter is too dirty and has not been replaced for a long time- replacethe filter. Water has got in the filter or the purifier has been used in humid environment- replace the filter. Reuse after storage for some time clean the filter or Odor replace the filter if the problem can not be solved.
Need help?
Do you have a question about the HQZZ-260 and is the answer not in the manual?
Questions and answers
Could you please tell me how to reset the filter light I put a brand new filter in I unplugged it and I cleaned it all up and then I plugged it back in and the filter light was still on. I did try the pressing whole power button, but it just shuts it off And does not reset the light.
@Lori Davis press the timer button for 3 seconds
To reset the filter light on a Tailulu HQZZ-260 after replacing the filter, hold down the button for 3 seconds until the light turns off.
This answer is automatically generated
How do I reset the filter when there is no filter button reset
@Sandy Williams press the timer button for 3 seconds
To reset the filter on the Tailulu HQZZ-260, press and hold the button that blinks when the filter screen expires for 3 seconds after replacing the filter. The light will turn off, indicating the reset is complete.
This answer is automatically generated
resetting the filter light
To reset the filter light on a Tailulu HQZZ-260 air purifier, hold down the button for 3 seconds after replacing the filter. The light will turn off, indicating the reset is complete.
This answer is automatically generated
@Sharon press the timer button for 3 seconds
How do I turn the filter light off after I replaced the filter?