Table of Contents
Advertisement
6.
Mounting
6.1
Mortice Installation (Solid Wood)
1. Cutting the mortice
Referring to the product dimension drawings, a mortice
is cut into the door frame to fit the lock and a mortice is
cut into the door leaf to fit the strike. Wooden doors and
frames require full mortices with space made behind the
lock body to accommodate the wire connections.
It is crucial to ensure that the mortices in the door leaf
and frame are aligned vertically and horizontally when
the door is closed as this aligns the bolt pin to the strike
opening and also the strike magnet to the locks internal
door position sensor.
Ensure that the final gap between the lock face plate and
strike plate once it is installed will be no more than 6mm
(1/4 inch).
2. Wiring the lock
A hole needs to be drilled in the back of the mortice to
bring the wires out and a connection can be made to the
supplied wire loom which in turn plugs into the lock.
Refer to the Wiring section of this document for detailed
instructions on wiring.
3. Setting the operating mode
Ensure the operating mode switch is positioned to the required
state, Fail Safe or Fail Secure.
Refer to the Operating Mode section of this document for
detailed instructions on wiring.
4. Fitting the lock and strike plate
The lock can be slid back into the door frame mortice, ensuring
that the wiring integrity is maintained, and then secured in place
with the supplied 10G self-tapping screws. Please ensure the
lock is the correct orientation as to pull the door into the door
jamb.
The strike is then placed into the door leaf mortice and the
remaining 10G self-tapping screws are used to secure it in
place. Ensure the strike is oriented so that the bolt hole aligns
with the lock bolt.
16
Advertisement
Table of Contents
