Advertisement
BASIC FUNCTION CONTINUED...
ANTIFREEZE MODE
Protects the radiator from freezing — the minimum
temperature setting is 5°C and the maximum
temperature setting is 15°C (buttons + and -). In
Antifreeze mode the heating element will stay in the
OFF position until the temperature drops below the
limit set. To set up ANTIFREEZE mode press MODE
button until
appears.
TURNING OFF
To turn off the heating element press MODE button
until
symbol appears. In this state the ANTIFREEZE
saver is off. To activate it you have to choose
ANTIFREEZE mode (appears).
TIME SETTING
To set time:
1. Press MODE key for 5 sec. (hour-diodes will flash),
2. With + and - buttons change the hour then
approve it by pressing MODE button.
3. Change the minutes (+ and -) and then press
MODE to finish.
ADVANCED FEATURES
CALIBRATION OF TEMPERATURE SENSOR
If you notice a difference between a thermometer
temperature and your displayed ambient tempera-
ture then the temperature sensor has to be
calibrated (regulation within +/-5°C, accuracy
0,1°C):
1. press both + and - buttons, (the
flashing)
2. press MODE so
3. with + and - keys set value of correction (preset
value of correction is 0,0°C).
4. after 15 sec. new settings will be written.
Example: Lowering displayed
temperature by 1.5°C.
3
icon will start
is displayed,
CHANGE OF DISPLAY INFORMATION
As a default setting the controller displays the current
ambient/room temperature. By pressing + or - you
are able to display for 5 seconds the desired set
temperature. It is possible to set the controller to
display the 'set temperature' or 'current time' instead
of the ambient/room temperature. (User can see
other information by pressing + or - button).
How to change the display information:
1. Press both + and - at the same time for 5 seconds
—
icon will start flashing and
2. With + and - keys change the configuration. The
changes will be set and displayed after 15 sec.
current ambient/room temperature
set ambient/room temperature
current time
CHANGE OF COMMUNICATION CHANNEL
The TERMA-IR remote controller DTIR1 works with
more than two devices (TERMA-IR heating elements)
in the same room — in order to do this all of the
devices have to be set on the same communications
channel (default setting is 0). To change/set channel of
communication in DTIR1 controller:
1. Enter configuration change mode by pressing + and
– key at the same time (
2. press MODE until
icon is displayed,
3. with + and - to set the proper channel (from 0 to
3), the same one must be set in every receiver.
4. wait 15 sec to overwrite new settings.
icon will appear.
icon is flashing),
Advertisement
