RADOX DTIR1 Instructions

SIDE
TECHNICAL DATA
- Voltage: 2 x 1,5 V (alkaline batteries AA (LR03))
- Storage temperature: –10-70°C
- Operating temperature: 0-40°C
- Dimensions: 80 x 80 x 23 mm
- Protection degree: IP30
- Radius of action: 12 m
- Angle of emission: 40°
GENERAL INFORMATION
Optimal location for the fitting of the device:
• Recommended height on the wall ~1.5-1.8 m
• Min. 20 cm from the door and away from all
drafts
• Cold walls can decrease displayed ambient
temp.
• Best position is the wall opposite to the
TERMA-IR heating element.
• Before final installation check the connection
quality using hints from 'Signal confirmation'.
• Do not cover the device with towels, clothes etc.
To see mounting holes take off the front panel and
take the batteries out.
1
FRONT
DTIR1 multifunctional remote controller is equipped
with an IR transmitter that allows the user to control
a number of TERMA-IR equipped heating elements
fitted to radiators in one room at the same time.
A built-in temperature sensor enables control and
regulation of ambient temperatureand it's modern
construction guaranties easy installation and use.
Equipped with a 24 hr timer this controller uses an
advanced regulation algorithm to control the temperature
requirements to suit all of your current needs.
Thermostatic Remote Control
Daily Timer Instructions
BACK
To see mounting holes take off the front panel and
take the batteries out.
SIGNAL CONFIRMATION
IR transmitter emits special control signal:
• in cycles — every 10 minutes,
• when user presses any key,
• every time when modes are changed (i.e. AUTO
changed to ANTIFREEZE).
Every TERMA-IR equipped heating element
placed within the controller's reach and working
in the remote mode will confirm every correctly
received signal on its front panel (see details in the
manual of your heating element).
SIDE
pic. 1