Summary of Contents for Thunderstone THUNDER POWER TARP 7000
Page 1
THUNDER POWER TARP 7000 OPERATION INSTRUCTIONS 3400 West O Street Lincoln, NE 68528 402-435-4249 (Fax) 402-438-3918 www.thunderstonemfg.com REV B February 22, 2023...
Page 2
P a g e USE THE PROCEDURES BELOW TO OPERATE THE TARP SYSTEM Powering up or down the system • By default the keypad will turn on after Fig 2.1 Status power is applied. To turn the system on or Light off, locate the “...
Page 3
P a g e Remote Programming 1. Ensure the keypad is powered on. The Thunder 7000 keypad will power on by default, but if the keypad is not powered on, press and hold the "OPEN" and "CLOSE" buttons for 5 seconds or until the keypad illuminates, indicating the system is active.
Page 4
P a g e MANUAL OPERATION Your Thunder Electric Tarp System should operate smoothly and provide years of service. In the unlikely event that an issue arises, please follow these instructions to manually open and close the tarp system. 1. Remove the motor shaft drive nut and bolt assembly from the roll tube axle.
Need help?
Do you have a question about the THUNDER POWER TARP 7000 and is the answer not in the manual?
Questions and answers