Advertisement
step four: Attach the red Support Fingers using the 1/4" Carriage Bolt and 1/4" Nuts as shown in
figure 3.
step five: Connect the Ramp sections. Attach them using 3/8" Bolts, 3/8" Washers and 3/8" Nuts
as shown in figure 4 below.
note: Both joint plates on
the lower section go on the
outside.
figure 4
step six: To improve the traction on the deck, adhesive grip tape or a layer of grip coating may be
used (not included). When you are finished using the Ramp, it can be folded for easy storage (as
shown below).
The Ramp must be used on a flat, dry, and level surface. To prevent the Fingers from slipping off the
loading surface, you can drill a hole at the end of each Support Finger, then bolt or screw it down to
the loading surface. Always make sure the loading surface is solid, dry and secure.
SKU 94643
deck
installation instructions:
for technical questions, please call 1-800-444-3353.
figure 3
note: Both joint plates on
the upper section go to the
inside.
Drill holes here
Page 6
Advertisement
