Advertisement
S
S
/ V
C
S
P E A K E R
E L E C T I O N
O L U M E
O N T R O L
Y S T E M
3. Make the connections to the SVL-4AB. The
amplifier/speaker connectors on the SVL-4AB are removable.
If you wish, you may remove the SVL-4AB's connectors to
facilitate installation [see (Figure 3)]. Strip 3/8" of insulation
from the end of each wire. Tightly twist the end of each wire
until there are no frayed ends. Insert each wire into the
appropriate hole on the connector terminals. Be certain that
proper "phasing" is observed . To achieve proper phasing,
connect the positive terminals on the SVL-4AB to the positive
terminals on the amplifiers and speakers and the negative
Figure 3
Removing the
terminals on the SVL-4AB to the negative terminals on the
Connectors
amplifiers and speakers. If you are using only one amplifier it
should be connected to the "Amplifier A" connector and the
pushbutton switches marked "A/B" should be left out or in
the "A" position. If you will be using two amplifiers, connect
the second amplifier to the "Amplifier B" connector on the
SVL-4AB. Re-install the connectors if they were removed. See
(Figure 4).
4. Locate the pre-printed Room Labels. Affix the appropriate
label to the recessed area over each ON/OFF selector button.
Figure 4
Installing the Connectors
10
Advertisement
