Troubleshooting - HAMOKI B10 Instruction Manual

TROUBLESHOOTING

PROBLEM
The mixing shaft
does not rotate
after switch on
Oil leakage
The raising handle
is too tight
Temperature rise
of motor is too
high, below speed
POSSIBLE CAUSES
Electric connectors are
loose
Oil seals are worn out
Guide ways are corroded
The lead screw, bevel gear
and hand wheel shaft etc. is
dry
Lack of voltage
Overload
The working speed selected is
too high or agitator is not
suitable
SOLUTION
Check the electric
circuit, tighten those
loose connectors
Replace the oil seals
Clean and oil the guide
ways
Oil them
Check the supply voltage
Less load
Select a suitable speed
and agitator
18