Niles RVL-6 Installation & Operation Manual page 36

In the following example, the H
switches are set to increment the unit code by two.
A-1 CEILING LIGHT
A-2 SPEAKER PAIR ONE
A-7 CEILING LIGHT
A-8 SPEAKER PAIR FOUR
2. When you are using a mixture of two, three and four button wall switches.
Each wall switch will operate the RVL-6 from the same button position. The starting address will determine
whether the first button, second button or the third button controls the RVL-6. You can assign house codes to
your lights and appliances different from the RVL-6, so that the All-On and All-Off commands from your pow-
erline carrier controllers will turn only the RVL-6 speaker pairs on and off.
In the following example, the H
switches are set to increment the house code by one.
A-1 CEILING LIGHT
A-2 SPEAKER PAIR ONE
D-1 CEILING LIGHT
D-2 SPEAKER PAIR ONE
Operating the RVL-6 Using X-10 Power Line Controllers
RVL-6 Command
ON/OFF
ALL ON
ALL OFF
VOLUME UP
VOLUME DOWN
Please Note that not all Powerline Carrier controllers offer the Brighten/Dim buttons.
code is set to A, the U
OUSE
ROOM ONE
A-3 CEILING LIGHT
A-4 SPEAKER PAIR TWO
ROOM FOUR
A-9 CEILING LIGHT
A-10 SPEAKER PAIR FIVE
code is set to A, the U
OUSE
ROOM ONE
B-1 CEILING LIGHT
B-2 SPEAKER PAIR TWO
B-3 LAMP
ALL-ON ALL-OFF
ROOM FOUR
E-1 CEILING LIGHT
E-2 SPEAKER PAIR TWO
E-3 LAMP
ALL-ON ALL-OFF
Powerline Carrier Equivalent
ON/OFF
ALL ON
ALL OFF
BRIGHTEN
DIM
Code is set to Two, and the INCREMENT
NIT
ROOM TWO
A-5 CEILING LIGHT
A-6 SPEAKER PAIR THREE
ROOM FIVE
A-11 CEILING LIGHT
A-12 SPEAKER PAIR SIX
Code is set to Two, and the INCREMENT
NIT
ROOM TWO
ROOM FIVE
36
ROOM THREE
ROOM SIX
ROOM THREE
C-1 CEILING LIGHT
C-2 SPEAKER PAIR THREE
C-3 LAMP
ROOM SIX
F-1 CEILING LIGHT
F-2 SPEAKER PAIR THREE
F-3 LAMP