Table of Contents
Advertisement
PROGRAM EDITING STEPS
Edit IR Commands for Source 6:
ton until the
SOURCE 5/6 LED is GREEN, and the IR
COMMANDS
LED blinks.
Skip to Step 2.
Edit IR Commands for Source 7:
ton until the
SOURCE 7/8 LED is RED, and the IR
COMMANDS
LED blinks.
Skip to Step 2.
Edit IR Commands for Source 8:
ton until the
SOURCE 7/8 LED is GREEN, and the IR
COMMANDS
LED blinks.
Skip to Step 2.
Step 2 - Press a Function Button on the Niles R-8
Remote that corresponds to the source-component IR
command you wish to teach. The
lights red.
SEQUENCE EDITING
To program the control sequences for the source
components:
Step 1 - Press and hold the PROGRAM button.
The
PROGRAM LED lights, the TUNER 1/2 LED
lights, the
SEQUENCE LED blinks, and the ENTER IR
LED is on.
Edit a sequence for Source 3:
until the
SOURCE 3/4 LED is RED, and the
SEQUENCE LED blinks.
Skip to Step 2.
Edit a sequence for Source 4:
until the
SOURCE 3/4 LED is GREEN, and the
SEQUENCE LED blinks.
Skip to Step 2.
Edit a sequence for Source 5:
until the
SOURCE 5/6 LED is RED, and the
SEQUENCE LED blinks.
Skip to Step 2.
Edit a sequence for Source 6:
until the
SOURCE 5/6 LED is GREEN, and the
Tap the
NEXT
but-
Tap the
NEXT
but-
Tap the
NEXT
but-
ENTER IR LED
Tap the
NEXT button
Tap the
NEXT button
Tap the
NEXT button
Tap the
NEXT button
70
Step 3 - Using the
source component's factory remote,
teach the IR command. The
Step 4 - Immediately after capturing the IR
test it by pressing the
TEST IR button. If the
component does not respond correctly to the IR com-
mand, try reteaching the command at various dis-
tances from a half-inch (roughly a centimeter and a
quarter) to three feet (almost a meter).
Step 5 - Repeat all steps until you have taught all of
the source-component IR commands.
Step 6 -
Tap the
PROGRAM button
ming.
SEQUENCE LED
blinks.
Skip to Step 2.
Edit a sequence for Source 7:
until the
SOURCE 7/8 LED is RED, and the
SEQUENCE LED blinks.
Skip to Step 2.
Edit a sequence for Source 8:
until the
SOURCE 7/8 LED is GREEN, and the
SEQUENCE LED blinks.
Skip to Step 2.
Step 2 - Press the keys on the Niles R-8 Remote that
correspond to the commands you wish to include in
the sequence.
Enter commands and delays in the order you wish
them to occur. The sequence may include as many as
64 commands and/or delays. To include a delay, use
the Volume + key (1 second) or Volume - key (.5 sec-
ond). The
ENTER IR LED blinks when it receives a
command.
Step 3 -
Tap the
PROGRAM button to exit
ming.
ENTER IR LED turns off.
command,
source
to exit program-
Tap the
NEXT button
Tap the
NEXT button
program-
Hide quick links:
Advertisement
Table of Contents
