Terminating Four-Pair Twisted Cable; Connecting The Master Keypads To The Home Run Of Four-Pair Twisted Cable; Connections; Connecting Accessory Keypads - Niles ZR-8630AV Installation & Operating Manual

CONNECTIONS

TERMINATING FOUR-PAIR TWISTED CABLE

The Select and Solo Master Keypad Modules, the Expander, and the ZR-8630AV unit's system-expansion con-
™ ™
nections require a four-pair twisted cable with a one-to-one wiring configuration. To maintain consistency
throughout all IntelliPad
you may adopt a different color-coding pattern if you use it consistently throughout the system. IMPORTANT:
use VW-1 rated wire for connection to KEYPADS and 12V OUT terminals.
1 = Green/White
2 = Green
3 = Orange/White
4 = Blue
5 = Blue/White
6 = Orange
7 = Brown/White
8 = Brown
Figure 32
CONNECTING ACCESSORY
KEYPADS
Jumper cables (included) mate each
Master Keypad Module with an
optional Accessory Keypad Module.
(See Figure 33.) The Select
Keypad Module mates with both
accessory modules; the Solo
only with the Numeric ™
® Ci installations, we recommend the color-coding pattern described in Figure 31, but
CONNECTING THE MASTER
FOUR-PAIR TWISTED CABLE
Terminate the home run of four-pair twisted cable with a male
RJ-45 connector. Plug it into the rear-panel SYSTEM jack on the
Select
™
Figure 32).
RJ-45 Connector
for connection to
IR Sensors
RJ-45 Connector
for connection to
Numeric
Keypad Module
Master
™
mates
™
.
Pair 3
1 2 3 4
Figure 31
, Select IR, Solo , or Solo
™ ™
RJ-45 Connector for
connection to
the ZR-8630AV
IR SENSOR SYSTEM
ACCESSORY
KEYPADS
™ Accessory
Included
Jumper Cable
™
Select
Master
Keypad Module
Figure 33
47
Pair 2
Pair 1 Pair 4
5 6 7 8
T568A
KEYPADS TO THE HOME RUN OF
IR Master Keypad Module (see
™
INPUT
OUTPUT
RJ-45 Connector
for connection to Master
Keypad Module
™
Numeric
Accessory
Keypad Module
INPUT
OUTPUT
™
Transport
Accessory
Keypad Module