Advertisement
The Strion Switchblade® must be charged before first use.
LED Radiation (RG-2)
Do not stare into beam.
May be harmful to eyes.
STRONG MAGNETIC FIELD
PINCH HAZARD
AVOID PAINTED METAL SURFACES
KEEP 12 INCHES FROM PACEMAKERS
Fully charge your flashlight before first use. The flashlight may be stored in the charger continuously when not in use or left plugged into the micro USB port.
To charge the light by the micro USB port. First turn off the light. Plug the USB cord into a power source, then fold back the rubber micro USB cover on the light, plug the micro USB end of the cord into the port. Take note the plug end is keyed for proper alignment. The charge indicator is located just below the rubber cover between the charge cradle contacts. The indicator will glow red for charging. It will blink when the cell is fully charged.
Charge times will vary depending on the current available from the USB port.
Charge time using the USB charge port on the light, using SL #22049, 22058, 22059, 22071, or 22072 charger, recharges in 4 hours.
To charge the flashlight in a Strion Charger. First turn it off and insert it into the charger. The triangular plate on the head fits into a mating recess in the charger. With the plate toward the charger, slip the barrel of the light between the charger arms and pull downward until it locks into place. The red LED on the charger housing must light to ensure that the battery is being charged.
Keep the flashlight and charger contacts clean at all times. Poor contacts can cause charger malfunction. An abrasive pencil eraser works well to clean the contacts.
Recharges light in 4 hours (5V/1A USB input) or 4 hours with 12VDC input.
Before mounting a Streamlight charger in a vehicle, please read the following sections.
The charger should never be mounted against any heat sensitive surface.
Before drilling any holes, make sure there is room to insert and remove the flashlight.
Two (2) self-tapping #8 x 2" screws are included to mount the charger.
The correct size hole for these screws in sheet metal is 1/8."
A 12VDC power cord (#22051) is equipped with a cigarette plug and is available for mounting a Streamlight charger in a vehicle. The plug can be removed and the wires can be attached directly to a power source for a more permanent installation. (A two amp fuse must be used on the positive lead.)
Before making electrical connections in a vehicle, keep in mind that a shorted auto battery can easily start a fire. Make all connections with insulated lugs or other connectors intended for such use. Be sure that your installation is fused. The striped power lead is positive and the unmarked lead is negative. When connecting the charger to a fuse block the striped, positive power lead goes to the connector that is dead when the vehicle's fuse is removed. The charger body is electrically isolated from the charge circuit and allows positive ground installations. The charger is diode protected and if connected in reverse polarity simply won't operate until connected properly.
Streamlight recommends connecting chargers to an unswitched source of power to ensure the flashlight is always fully charged. If the vehicle will not be driven for several days, the flashlight should be removed from the charger to avoid vehicle battery drain.
To replace the Streamlight Li Ion cell. Rotate the foot counter clock wise two turns to unscrew and remove the base. Slide the battery out and replace with another Streamlight 74175 cell. Slide the new battery into the barrel with the positive end entering the barrel first. Replace the bottom cover and rotate until the lock engages.
To register your product, go to www.streamlight.com (Online Product Registration).
Retain your receipt or any proof of purchase.
Streamlight flashlights are intended for use as high intensity, heavy duty, portable light sources. Use of Streamlight flashlights for any purpose other than as light sources is specifically discouraged by the manufacturer.
Be sure to use only genuine Streamlight® replacement parts.
To assure product safety and reliability, repairs other than those listed below should be performed at the Streamlight factory. Always use Streamlight approved replacement parts, substitution may invalidate underwriter's approval.
Streamlight warrants this product to be free of defects for a lifetime of use except for batteries and bulbs, abuse and normal wear. We will repair, replace or refund the purchase price of this product should we determine it to be defective. This limited lifetime warranty also excludes rechargeable batteries, chargers, switches and electronics which have a 2 year warranty with proof of purchase.
Go to www.streamlight.com/support for a complete copy of the warranty, and information on product registration and the location of authorized service centers. Retain your receipt for proof of purchase.
The Strion Switchblade® contains few or no user-serviceable parts.
For Service options, go to www.streamlight.com/support/service and complete the Online Service Request for factory service or to find the location of an authorized Streamlight repair center near you.
Or contact:
Customer Service
STREAMLIGHT, INC.
30 Eagleville Road Suite 100
Eagleville, PA U.S.A. 19403-39996
Phone: (800) 523-7488 Toll-Free or 610-631-0600
Fax: (800) 220-7007 or 610-631-0712
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download StreamLight STRION SWITCHBLADE - Rechargable LED Light Bar Manual
Advertisement
Need help?
Do you have a question about the STRION SWITCHBLADE and is the answer not in the manual?
Questions and answers